Author Topic: Somewhere with a table saw  (Read 2431 times)

Offline healy

  • Member
  • *
  • Posts: 25
  • I'd buy that for a dollar
    • View Profile
    • Jersey City Bar Guide
Re: Somewhere with a table saw
« Reply #5 on: 05-13-2010, 04:12pm »
Thanks Brewster...

I'm just looking for a molded Masonite 6 panel thingy... I like your attention to detail!

Offline brewster

  • Member
  • *
  • Posts: 44
    • View Profile
Re: Somewhere with a table saw
« Reply #4 on: 05-13-2010, 11:36am »
Keep in mind you could be opening a can of worms you need to deal with.

If the lockset holes are already drilled, you can't cut that side of the door or the backset would now be wrong.

If it's a new "solid wood" door to be natural finished rather than painted, the edges may be actually veneered, so when you trim them knots will appear.

Offline healy

  • Member
  • *
  • Posts: 25
  • I'd buy that for a dollar
    • View Profile
    • Jersey City Bar Guide
Re: Somewhere with a table saw
« Reply #3 on: 05-13-2010, 11:07am »
Thank you kindly, Sir!

Online fasteddie

  • Senior Member
  • ****
  • Posts: 839
    • View Profile
Re: Somewhere with a table saw
« Reply #2 on: 05-13-2010, 09:33am »
If you're downtown, try Henderson, they specialize in doors. Palisade Lumber in the heights will do it too.

Offline healy

  • Member
  • *
  • Posts: 25
  • I'd buy that for a dollar
    • View Profile
    • Jersey City Bar Guide
Somewhere with a table saw
« Reply #1 on: 05-13-2010, 05:38am »
Hi All,

Tried searching on this to no avail.

I need 1/4 of an inch squarely ripped from the width of a standard, 30"x80" door.

Home Depot, Lowes, and Dykes will not do it.  The latter two did mention I could order the door, but that seems like waste of time.

I'd gladly pay to have someone do this.  Any ideas?

Thanks,
Rob

Jersey City, NJ Community Forums

Somewhere with a table saw
« Reply #1 on: 05-13-2010, 05:38am »